Probe TODO
From Glacsweb Wiki
Calibrate and test Strain
Tilt
Compass
Temp
Water pressure
Interface issues
- node status just returns
nodestatus 34 #RESPONSE: 47 57 22 22 81 00 03 22 33 00 8B 9B OK
No parsable status data in there
- rtcget 34
rtcget 34 #RESPONSE: 47 57 22 22 86 02 04 B7 14 1B 50 F2 B0 OK
No parsable data
- rtccounterget
rtccounterget 34 #RESPONSE: 47 57 22 22 88 03 04 E1 F4 35 00 55 4A OK
Revision 12.2
TODO
- Sort out programming header
- way of disabling LED
- way of disabling buttons
- RS232/RS484 converter
- accelerometer mod
- power connector?
- silk screen
- conductivity
- Vdd issue/ Vref
- strain
- hardware mods
- sleep current
- cc1120 pcb tune-up
- code tweaks like colour code led specs etc, timeouts, shell, binary data files
- calibprobedata converter
Revision 12.1
- Fixed opamp cap too close
- Did NOT switch SWCLK and SWDIO due to pinouts
- Did NOT add calibrated temp sensor
- Added ITG3050 Gyro sensor (with built in temp sensor)
- Fixed MCU Reset
- Removed 5V reg for radio board
- Added picoflex connectors
- Added Top layer connector
Revision 12.0
12.0 These things need to be done.
- Fix PCB opamp middle of b-layer and cap too close
- Fix pcb designs for the following:
- MCU_RESET needs to be connected to the same net
- SWCLK and SWDIO needs to be switched
Ideas regarding Probe 2012-2
- Add Calibrated temp sensor Maybe: MCP9808 along with Platinum sensor
- Update to Geoff Conductivity sensor - also need calibration
- Use new radio modules... Not sure which ones... maybe the CC1120 CC1120 TI Page because then we can use the same code for the Upper radio network as well as the ice radio network
